Colored ceramic abrasive grain anti-skid road surfaces are created by using special glue to adhere ceramic particles to the surface of existing roads, thus forming anti-skid colored road surfaces, which are widely applied to transportation roads throughout the world. What are some reasons for damage to ceramic abrasive grain particles during use?
The shaped colored ceramic abrasive grain anti-skid road surface can prevent all construction vehicles and prevent scattered fragments from polluting the road surface. Do not pile up mortar and concrete debris on it. Cover the ceramic abrasive grain particles with plastic sheets when they enter the site to prevent the ceramic abrasive grain particles from being polluted during construction.
Choosing a roller with a low frequency and high amplitude can cause the tamping hammer to bounce, damage the flatness of the colored ceramic abrasive grain anti-skid road surface, while picking a heavy roller will cause the newly paved grainy road surface to be pushed and deformed, affecting the flatness of the road surface.
During the pressing process, high or low temperatures can affect the flatness of the plate. Therefore, selecting a suitable road roller to produce high-quality ceramic abrasive grain particles is very important.
During the construction process, construction personnel should prevent the ceramic abrasive grain particle mixture from being contaminated and ensure that the construction site is clean and standardized. If the ceramic abrasive grain material is damaged before laying, it is easy to rework and regenerate. However, if it becomes a sidewalk, repair is difficult and may be damaged.
Colored ceramic abrasive grain anti-skid road surface is a road beautification technology that can make traditional black asphalt concrete and gray cement concrete road surfaces colorful and anti-skid. What are some repair methods when colored ceramic abrasive grain anti-skid road surfaces are damaged?
Be prepared to prevent damage, that is, before the colored ceramic abrasive grain anti-skid road surface material is officially put into use, cover the national standard anti-skid road surface material directly to prevent problems such as discoloration and fading after exposure to ultraviolet light.
Dismantle the already constructed colored ceramic abrasive grain anti-skid road surface and restore the original anti-skid groove on site.
Remove the colored ceramic abrasive grain anti-skid road surface, the parts of the falling vehicle shed, and re-lay standard anti-skid materials.
Colored ceramic abrasive grain anti-skid road surface is convenient to lay on cement and asphalt surfaces without changing the road structure, and is easy to renovate old roads. It has a fast and simple construction with a short sealing road construction time and requires a small construction site and road closure range.
It has good low-temperature resistance and is suitable for use in areas with severe cold. It has excellent heat aging performance and high-temperature stability. It will not reduce the net height of the passage. It is lightweight and will not increase the load-bearing capacity of the bridge.
The above describes the repair methods for colored ceramic abrasive grain anti-skid road surfaces. Through these descriptions, it is believed that everyone has a deeper understanding of ceramic abrasive grain materials for road surfaces. It has excellent comprehensive performance except for epoxy resin and is mainly aimed at the early strength of resin normal temperature curing to improve its resistance to ultraviolet light.
English
한국어
français
Deutsch
Español
italiano
русский
português
العربية
tiếng việt
Polska